VEGE Remanufactured DC92 2.8L 173ci Premium Grade Long Block Engine

Description

Rear two-piece rope seal weepage and lower intake manifold corner oil push terminate upon sourcing the VEGE Remanufactured DC92 2.8L Long Block Engine. Outputting 125HP from its 173ci 6-Cylinder commercial long block repower format, this unit powers municipal delivery vans. Technicians must sort differential intake and exhaust pushrod lengths prior to torquing down individual rocker arm pivot studs.

Constructed around a 60-degree ASTM A48 Class 30 gray iron block with iron heads, this engine resists warping under load. The VEGE engine core incorporates induction-hardened nodular iron camshaft lobes paired with stellite valves. Starter electrical draw requires 12V 145A. Dry unrigged mass measures 325 lbs across a 22in length, 22in width, 24in height stance with 4.0 quarts capacity.

Key Features of VEGE DC92

Regional transport fleets buy VEGE DC92 commercial long block units to stop recurring intake sealing breakdown. Assembly cells maintain verified industrial engine rebuild clean-room assembly practices throughout production.

• Forged micro-alloy steel crankshaft features micro-polished bearing surfaces with 0.0003in TIR runout tolerance.
• Upgraded one-piece rear main seal carrier conversion stops persistent oil pan rail leaks.
• Diamond plateau-honed cylinder liners establish immediate compression ring seal during break-in running.
• Tri-metal copper-lead bearings maintain 0.0014in hydrodynamic running clearance to stop crank journal scoring.
• Precision-ground pushrod guide channels eliminate lateral valvetrain bind across high operational engine hours.
• DC92 commercial core layout uses structural webbing along the engine valley to arrest chassis vibration.
• High-capacity internal oil pump sustains 48 PSI line pressure across demanding fleet highway duty.

Dynamic Bench Load Operating Thresholds

Automated test cells indicate 125 continuous BHP and 150 ft-lbs torque output at 4600 RPM continuous sweep testing. Instrumentation logs 48 PSI oil gallery pressure at 190°F oil sump temperature, while exhaust gas temp records 1190°F under dyno pull. Gauge checks verify 180 PSI compression across all six cylinders within 4% variance. Center journal deflection clocks at 0.0003in TIR on the DC92 long block engine.

Vehicle Setup Guidance Maintenance Rules

Mechanical throttle lever operation takes 4 lbs pull force through the linkage bracket assembly. This engine is NOT engineered for longitudinal heavy rear-wheel drive trucks or industrial marine drive installations. Shop mechanics must observe verified commercial engine service procedures without exception.

• Flush break-in engine oil and swap spin-on filter at 500 miles service interval.
• Check hydraulic roller lifter pre-load depth between 0.030in and 0.040in before valve cover installation.
• Inspect cooling water crossover pipe O-ring compression seal after initial operating heat cycle.

Warranty Statement Wood Crate Inventory

Engine remanufacture follows VEGE assembly standard procedures protected by a 3-Year 100,000-mile fleet warranty. The enclosed wood crate contains the fully assembled long block, stamped sheet-metal oil pan, front timing cover, stamped valve covers, oil pickup tube, and an inspector-certified dyno test document.