Bell & Gossett e-1532 1.25AD Centrifugal Pump 1HP 1750RPM

Run compact boiler loops with Bell & Gossett e-1532 1.25AD centrifugal pump for close-coupled hydronic circulation. Its 1 HP, 1,750 RPM configuration uses a 1.5-inch suction, 1.25-inch discharge, and in-line piping support. The supplied 9.5-inch impeller diameter requires confirmation against the final trim and pump curve. Check suction conditions, piping alignment, and service clearance before installation.

The 1.25AD Series e-1532 is a close-coupled footless end-suction pump intended for boiler recirculation and compact secondary loops. The supplied data identifies a 1 HP, four-pole motor and piping-supported installation. Flow, head, seal construction, pressure, temperature, dimensions, weight, and exact motor enclosure are not stated, so verify the complete duty point and installation details before ordering.

Key Features & Benefits

• 1 HP Motor: Fits compatible boiler recirculation and compact secondary-loop systems.
• 1,750 RPM Speed: Provides the supplied four-pole operating reference.
• 1.25AD Case Size: Identifies the 1.5-inch suction and 1.25-inch discharge arrangement.
• Close-Coupled Design: Combines the pump and motor in a compact installation package.
• Pipe-Supported Mounting: Requires suitable piping support and alignment during installation.
• 9.5-Inch Nominal Impeller: Requires confirmation against the final trimmed performance curve.

Why Choose Bell & Gossett e-1532 1.25AD

The 1.25AD configuration suits compact boiler loops where end-suction hydraulics and piping-supported mounting are preferred. Its impeller trim must be confirmed before using the supplied size for performance selection.

• Build: Close-coupled footless construction defines the supplied pump arrangement.
• Value: Confirming suction, discharge, and impeller trim can reduce retrofit errors.
• Audience: Fits boiler technicians, HVAC contractors, facility engineers, and commercial heating teams.

Applications & Use Cases

Use this pump in boiler recirculation and compact secondary loops that match the verified curve. Check the 1.5-inch suction, 1.25-inch discharge, pipe supports, valve clearance, motor access, and impeller trim. Flow, head, dimensions, weight, pressure, and temperature are not supplied.

Warranty & Support

• Warranty Terms: Warranty duration and coverage for this e-1532 configuration require confirmation from the authorized seller.
• Coverage Review: Confirm seal coverage, installation requirements, exclusions, and claim procedures before purchase.
• Model Verification: Match Bell & Gossett e-1532 1.25AD, 1 HP, 1,750 RPM, and supplied case details to the order.

Verify the impeller trim, suction, discharge, seal, and pump curve, then align the piping, purge air, and check for leaks during startup. Purchase the Bell & Gossett e-1532 1.25AD centrifugal pump at Mulmotor.com for genuine equipment, applicable warranty coverage, and pump support.