Bell & Gossett e-1510 1.25AD Centrifugal Pump 1HP 1750RPM 3-Phase TEFC

Handle harsh boiler-room conditions with Bell & Gossett e-1510 1.25AD centrifugal pump for small boiler loops and dusty environments. Its 1 HP, 1,750 RPM four-pole motor uses a TEFC enclosure and three-phase power, while the 1.5-inch suction and 1.25-inch discharge define the case size. The base-mounted layout requires proper alignment and support. Confirm the pump curve, coupling arrangement, and piping before installation.

The 1.25AD Series e-1510 uses a base-mounted centrifugal arrangement with a TEFC motor and trimmed impeller listed at approximately 8.5 to 9.0 inches nominal. Its three-phase motor runs at 1,750 RPM, and the case uses a 1.5-inch suction with a 1.25-inch discharge. The supplied specifications do not state voltage, flow, head, seal material, dimensions, weight, or pressure, so verify those details against the manufacturer’s submittal.

Key Features & Benefits

• 1 HP Motor: Fits compatible small boiler-loop circulation duties.
• TEFC Enclosure: Helps protect the motor in dusty or harsh environments.
• 1,750 RPM Four-Pole Speed: Provides a defined operating reference for selection.
• Three-Phase Motor: Supports commercial and industrial electrical service after field verification.
• 1.5-Inch Suction: Identifies the inlet size for piping review.
• 1.25-Inch Discharge: Defines the outlet size for system connection planning.
• Base-Mounted Design: Requires proper support and shaft alignment during installation.

Why Choose Bell & Gossett e-1510 1.25AD

The 1.25AD combines a TEFC motor with a base-mounted e-1510 centrifugal arrangement. It suits smaller boiler loops and industrial areas where the motor enclosure must handle more dust than an open motor design.

• Build: TEFC motor, base-mounted construction, and trimmed impeller define the supplied assembly.
• Value: The enclosed motor design can support service planning in dusty equipment areas.
• Audience: Fits boiler technicians, industrial HVAC contractors, plant engineers, and maintenance teams.

Applications & Use Cases

Use this pump in small boiler loops and harsh or dusty environments that match the manufacturer’s hydraulic requirements. Check the 1.5-inch suction, 1.25-inch discharge, base support, coupling alignment, motor access, and lifting path. Flow, head, dimensions, weight, pressure, and voltage are not supplied, so verify the installation envelope.

Warranty & Support

• Warranty Terms: Warranty duration, coverage, exclusions, and registration requirements require confirmation from the authorized seller.
• Service Requirements: Confirm whether authorized service is required for warranty claims.
• Model Verification: Match Bell & Gossett e-1510 1.25AD and the supplied 1 HP configuration to the seller’s order documentation.

Verify three-phase voltage, support the base, align the shaft and coupling, inspect the seal, purge air from the loop, and check for leaks during startup. Select from the actual pump curve. Purchase the Bell & Gossett e-1510 1.25AD centrifugal pump at Mulmotor.com for genuine equipment, applicable warranty coverage, and pump support.